ZyXEL Communications Prestige 861H-G1 User Manual page 242

Prestige 861H User's Guide
MODULE COMMAND
dreset
romreset
atsh
xmodemmode
socket
filter
ddns
32-4
Table 32-1 sys Command Summary
SUB- ARGUMENTS
COMMAND
switch [on|off]
cnt [value]
[crc|checksum]
netbios
disp
config <0:LAN to
WAN, 1:WAN to
LAN, 6:IPSec
pass
through><on|off>
debug
display
restart
logout
DESCRIPTION
Turns the watchdog firmware
protection feature on or off.
Sets (0-34463) or displays the
current watchdog count (in 1.6 sec
units).
Resets node and mask.
Restores the factory default
configuration file.
Displays the mode that Xmodem
uses.
Displays the system socket's ID #,
type, control block address (PCB), IP
address and port number of peer
device connected to the socket
(Remote Socket) and task control
block (Owner).
Displays the current NetBIOS filter
modes.
Sets NetBIOS filters.
Turns on/off the displaying of DDNS
debug messages.
Displays DDNS information.
Restarts DDNS.
This command has no effect.
System Commands