ZyXEL Communications Prestige 861H-G1 User Manual page 145

FIELD
Rem Login Type the login name that this remote node will use to call your Prestige. The login
name and the Rem Password will be used to authenticate this node.
Rem Password Type the password used when this remote node calls your Prestige.
Outgoing:
My Login Type the login name assigned by your ISP when the Prestige calls this remote node.
My Password Type the password assigned by your ISP when the Prestige calls this remote node.
Authen This field sets the authentication protocol used for outgoing calls. Options for this field
are:
CHAP/PAP – Your Prestige will accept either CHAP or PAP when requested by this
remote node.
CHAP – accept CHAP (Challenge Handshake Authentication Protocol) only.
PAP – accept PAP (Password Authentication Protocol) only.
Route This field determines the protocol used in routing. Options are IP and None.
Bridge When bridging is enabled, your Prestige will forward any packet that it does not route
to this remote node; otherwise, the packets are discarded. Select Yes to enable and
No to disable.
Edit IP/Bridge Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.3 –
Remote Node Network Layer Options.
Edit ATM Options Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.6 –
Remote Node ATM Layer Options.
Edit Advance This field is only available when you select PPPoE in the Encapsulation field.
Options
Press [SPACE BAR] to select Yes and press [ENTER] to display Menu 11.8 –
Advance Setup Options.
Telco Option
Allocated Budget This sets a ceiling for outgoing call time for this remote node. The default for this field
(min) is 0 meaning no budget control.
Period (hr) This field is the time period that the budget should be reset. For example, if we are
allowed to call this remote node for a maximum of 10 minutes every hour, then the
Allocated Budget is (10 minutes) and the Period (hr) is 1 (hour).
Schedule Sets This field is only applicable for PPPoE and PPPoA encapsulation. You can apply up
to four schedule sets here. For more details please refer to the Call Schedule Setup
chapter.
Nailed up This field is only applicable for PPPoE and PPPoA encapsulation. This field specifies
Connection if you want to make the connection to this remote node a nailed-up connection. More
details are given earlier in this section.
Session Options
Edit Filter Sets Use [SPACE BAR] to choose Yes and press [ENTER] to open menu 11.5 to edit the
filter sets. See the Remote Node Filter section for more details.
Idle Timeout (sec) Type the number of seconds (0-9999) that can elapse when the Prestige is idle (there
is no traffic going to the remote node), before the Prestige automatically disconnects
the remote node. 0 means that the session will not timeout.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
Remote Node Configuration
Table 19-1 Menu 11.1 Remote Node Profile
Prestige 861H User's Guide
DESCRIPTION
19-3