MK Diamond Products MK-377 Owner's Manual Operating Instruction & Parts List page 27

MK-377 SAW
BLADE STOPS TURNING
(A)
Check the ON/OFF Switch is in
the ON position
(D)
Verify the circuit breaker is at least
20 amps - if not, move to 20-amp
circuit
(B)
Verify all plugs are fully
connected
(B)
Verify circuit breaker not
tripped; if it is tripped, reset it
once only
27
TROUBLESHOOTING
(C)
Check to see if the Ground Fault
Circuit Interrupter (GFCI) tripped
(C)
Check power source voltage
is 120v - if not 120v, move to
another circuit