Lindy 25010 User Manual page 11

Speed / Duplex – to setup the link speed and duplex mode in force mode
The options for this function can be selected only when the Auto Negotiation is Disabled (in
force mode) for copper media. There are 4 options for this parameter:
100Mbps Full – to set the speed 100Mbps in full duplex mode
100Mbps Half – to set the speed 100Mbps in half duplex mode
10Mbps Full – to set the speed 10Mbps in full duplex mode
10Mbps Half – to set the speed 10Mbps in half duplex mode
NOTE: Only full duplex mode is supported for 1Gbps link speed. For copper media, this
system supports the link speed from 10Mbps to 1Gbps for auto mode, and from 10Mbps
to 100Mbps for force mode. For fibre media, only the 1Gbps link speed is supported for
both auto and force mode.
Flow Control – to enable/disable flow control function
Disable -- to disable for the port
Enable – to enable for the port
Default Priority – to setup the priority of frames which will be referenced in QOS function
0 – 7 – to set the priority level (range = 0 ~ 7)
Security – to enable/disable port security function
If the per-port security is enabled and if a received frame contains a source MAC address that
has already been learned in another port's address table but not aged out, then the frame is
dropped. Otherwise, the address table entry is updated with the new port's information and the
entry is updated.
Disable -- to disable port security
Enable – to enable port security
Jumbo Frame – to enable/disable jumbo frame function
If the per-port jumbo frame feature is enabled, the maximum frame size is 9216 bytes. In 100
Mbps mode, the maximum jumbo frame size supported is 9000 bytes
Disable -- to disable jumbo frame support
Enable – to enable jumbo frame support
After the desired options are selected for the above functions, click the Apply button to save the
current settings to the switch and go back to the Port Status Page. Click the Cancel button to go
back to Port Status page.
10