Disarming The System; Silencing An Alarm - NAPCO XP-400 Express Series User Manual

Disarming Your System when Returning
1
Enter your premises through the Entry/Exit door. The keypad will sound a steady tone to remind you to
disarm the system before your Entry Delay time expires.
2
ARMED
Enter your user code. The Red Armed light will go out, indicating that the system has been disarmed.
Note: If you make a mistake entering your code, press the
READY
SYSTEM
Alarm Indication
If the Red Armed light is flashing rapidly, an alarm occurred while you were away.
Proceed with caution!
For your own protection, leave immediately and call authorities from a neighbor's phone .
ZONE 1
ZONE 2

Silencing an Alarm

ZONE 3
In the event that the system goes into alarm due to a violated burglary zone, the bell or siren will sound and
the keypad sounder will also activate. To silence the system, enter your User code. The zone light of the
ZONE 4
zone which went into alarm continue flashing until
Disarming Your System / Silencing an Alarm


is pressed to reset the alarm memory.
key and re-enter the code.
9