Disarming The System; Silencing An Alarm - NAPCO GEMINI GEM-P400 User Manual

Disarming Your System / Silencing an Alarm
Disarming Your System when Returning
1
Enter your premises through the Entry/Exit door. The keypad will sound a steady tone to remind you to disarm the system
before your Entry Delay time expires.
2
Enter your User Code and press
Note: If you make a mistake entering your code, press
Alarm Indication
If the Red Armed light is flashing rapidly, an alarm occurred while you were away. Proceed with caution!
For your own protection, leave immediately and call authorities from a neighbors phone .

Silencing an Alarm

In the event that the system goes into alarm due to a violated burglary zone, the siren and the keypad sounder will activate and

the number of the zone in alarm will flash in the display. To silence the system, enter your User code followed by
The keypad sounder and siren will silence, but zone in alarm will continue to flash.
Press to reset this alarm memory.
Oi230a
page 9

.
The red Armed light will go out, indicating that the system has been disarmed.
and re-enter the code, followed by
.
 .
9
Tuesday, September 16, 1997 08:26