Before Requesting Help
Cordless Telephone
Problem
"No link to base
Place on cradle and
try again." is displayed
and an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset does not ring.
The handset display is
blank.
The handset display is still
(›)
blank after pressing
(‹)
CH (fi)
EDIT (fl)
,
or
You cannot store a name
and phone number in the
directory.
Cause and Remedy
≥You are too far from the base unit.
Move closer and try again.
≥Place the handset on the base unit and
try again.
≥Plug in the AC adaptor.
≥Raise the base unit antenna.
≥Locate the handset and the base unit
away from other electrical appliances
(p. 3).
≥Move closer to the base unit.
≥Raise the base unit antenna.
CH (fi)
to select a clearer
≥Press
channel in the talk, speakerphone,
intercom or remote operation mode.
≥The ringer volume is set to OFF. Set to
HIGH or LOW (p. 20).
≥The handset is in the standby mode
(›)
(p. 14). Press
(fl)
to turn the display on.
≥Charge the battery fully (p. 13).
,
.
≥You cannot store an item in the
directory while the unit is in the talk,
speakerphone or intercom mode, or
while the answering system is in use.
≥Do not pause for over 60 seconds while
storing.
"
(‹)
CH (fi)
,
,
or
EDIT
75