Before Requesting Help
Problem
The unit does not work.
The unit does not ring.
You cannot dial.
The other party suddenly
cannot hear your voice
during a conversation.
You cannot program items
such as the dialing mode.
You cannot store a phone
number in memory.
While programming, the
unit starts to ring and stops
the program.
You cannot redial by
(REDIAL)
pressing
Previously programmed
information is erased.
30
≥Check the settings (p. 6–12).
≥Remove the batteries and reinstall
them to reset the unit.
≥The RINGER selector is set to OFF.
Set to HIGH or LOW (p. 11).
≥Check that the dialing mode selection
is correct (p. 9).
≥Dial lock mode is set. To cancel the
mode, see page 25.
≥The dialed number is restricted. To
cancel, see page 27.
(MUTE)
≥
the conversation. If "
(MUTE)
press
≥Programming is not possible when a
call is put on hold.
≥Do not pause for over 60 seconds
while programming.
≥Programming is not possible when a
call is put on hold.
≥Check that the batteries are installed in
the unit and that the battery power is
not low.
≥Do not enter a phone number more
than 22 digits long.
≥To answer the call, lift the handset or
(SP-PHONE/HEADSET)
press
again from the beginning after hanging
up.
≥If the last number dialed was more
.
than 32 digits long, the number will not
be redialed correctly.
≥If the batteries installed in the unit
expire, programmed information may
be erased. Reprogram if necessary.
Remedy
may have been pressed during
" is displayed,
.
. Start