Table of Contents
Advertisement
Before Requesting Help
Problem
"No link to base.
Place on cradle and
try again." is displayed
and an alarm tone sounds.
The unit does not work.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset does not ring.
The handset display is
blank.
The handset display is still
blank after pressing
(‹)
BACK (fi)
,
or
(fl)
.
≥You are too far from the base unit. Move
closer and try again.
≥Place the handset on the base unit and
try again.
≥Plug in the AC adaptor.
≥Raise the base unit antenna.
≥Check the settings (p. 10–15).
≥Charge the battery fully (p. 11).
≥Clean the charge contacts and charge
again (p. 12).
≥Install the battery properly (p. 11, 48).
≥Place the handset on the base unit and
unplug the AC adaptor to reset. Plug in,
and try again.
≥Locate the handset and the base unit
away from other electrical appliances
(p. 3).
≥Move closer to the base unit.
≥Raise the base unit antenna.
≥Press
clearer channel.
≥The ringer volume is set to OFF. Set to
HIGH or LOW (p. 18).
≥If the line is connected to a low voltage
system such as a PBX, the unit may not
ring. Set the line mode to "B" (p. 15).
≥The handset is in the standby mode
(p. 12). Press
FWD/EDIT (fl)
≥Charge the battery fully (p. 11).
(›)
,
FWD/EDIT
Remedy
(FUNCTION/EXIT/CH)
(›)
(‹)
,
,
to turn the display on.
"
to select a
BACK (fi)
or
49
Advertisement
Table of Contents
