Fitting / Replacing An Abrasive Wheel - Stihl TS 800 Instruction Manual

Fitting / replacing an abrasive
wheel
The engine must be switched off for
fitting or replacement – set Master
Control lever to STOP or 0.
Blocking the shaft
Slide the locking pin (1) through the
N
bore in the V-belt guard
Turn the shaft with the combination
N
wrench until the locking pin (1)
engages in a bore behind the guard
TS 800
Removing a cutting wheel
Use the combination wrench to
N
loosen and remove the hexagon
head screw (2)
Remove the front thrust washer (3)
N
from the shaft together with the
cutting wheel
Fitting a cutting wheel
Fit the new cutting wheel (4)
N
WARNING
Note the arrows indicating the direction
of rotation on diamond cutting wheels.
English
21