Exclusion Of Liability - Gigaset E630H Operating Instructions Manual

The other party cannot hear you.
¥ The handset is "muted".
Activate the microphone again (
The caller's number is not displayed.
1. Calling Line Identification (CLI) is not approved for the caller.
¥
The caller should ask the network provider to enable Calling Line Identification (CLI).
2. Caller display (CLIP) is not supported by the network provider or is not enabled for you. ¥
Caller display (CLIP) is enabled by the network provider.
3. Your telephone is connected via a PABX or a router with an integrated PABX (gateway) that does not
¥ transmit all information.
Reset the system: Briefly pull out the power plug. Reinsert the plug and wait until the device restarts.
¥
Check the settings on the PABX and activate phone number display, if necessary. To do this, search for
terms such as CLIP, calling line identification, phone number identification, caller ID, etc. in the
system's user guide or ask the system manufacturer.
You hear an error tone when keying an input.
Action has failed/invalid input.
¥
Repeat the process.
Read the display and refer to the user guide if necessary.

Exclusion of liability

Your handset display has a resolution of 128 x 160 pixels. Each pixel consists of three sub-pixels
(red, green, blue).
It may be the case that a pixel is incorrectly controlled or has a colour deviation.
This is normal and no reason for a warranty claim.
The following table shows the number of pixel errors that may occur without leading to a
warranty claim.
Description
Colour illuminated sub-pixels
Dark sub-pixels
Total number of coloured and dark sub-pixels
Note
Signs of wear on the display and housing are excluded from the warranty.
Customer service & product warranty – Australia and New Zealand
¢
page 19).
Maximum number of permitted pixel errors
1
1
1
43