Final Safety Check List; Maintenance - Evolution RAGE3-DB Original Instruction Manual

Fig. 45
Fig. 46
Fig. 47

MAINTENANCE

NOTE: Any maintenance must be carried out with the
machine switched off and disconnected from the mains/
battery power supply.
Check that all safety features and guards are operating
correctly on a regular basis. Only use this machine if all
guards/safety features are fully operational.
All motor bearings in this machine are lubricated for life.
No further lubrication is required.
Use a clean, slightly damp cloth to clean the plastic
parts of the machine. Do not use solvents or similar
products which could damage the plastic parts.
WARNING: Do not attempt to clean by inserting pointed
objects through openings in the machines casings etc.
The machines air vents should be cleaned using
compressed dry air.
Excessive sparking may indicate the presence of dirt in
the motor or worn out carbon brushes. If this is suspected
have the machine serviced and the brushes replaced by a
qualified technician
Table Insert
A two piece table insert is fitted to this machine.
If either side is damaged or worn, both parts must be
replaced. Replacement inserts (sold in handed pairs)
are available from your supplier or
Evolution Power Tools.
To replace the table inserts:
• Remove the 3 or 4 cross-head screws that secure one
of the inserts to the rotary table.
• Lift the insert from the table.
• Remove any debris that may have accumulated
under the insert.
• Fit the replacement insert, and replace the three
fixing screws.
• Repeat the process for the other side.
• Check that all 6 or 8 fixing screws are tightened
securely, and that both inserts are lying flush and
level within the table.
www.evolutionpowertools.com 31