Table of Contents
Advertisement
3
Advanced Configuration
Alarm Manager: Use the Alarm Manager page to set the response (action) that results from an
individual alarm. It is possible to have more than one action for a single alarm by adding additional
rules (for example, one action could capture an image and another could generate an output). If a
message is to be sent from the camera as a result of an alarm, it is necessary to define Message
Systems and set up Notification Lists (refer to
(Media Browser, pg.
In general, each Alarm Rule describes an alarm Source and a single alarm Action. For the FC-Series
camera, the source of the alarm typically will be internal from the camera itself, although it is also
possible for the camera to receive alarms from another camera or device/server on the network (such
as a radar server, input/output server, ground sensor, fence system, or other security sensor).
Alarm Source: The source of alarms for the FC-Series S camera is typically internal from Video
Analytics and/or GPIO Input, while the FC-Series R camera also can have Radiometric IR alarms. In
these cases, the Alarm Source Server IP Address is set to the localhost value of 127.0.0.1 and the
TCP port is the default 1001. Otherwise the address and port are set to an external server. For internal
alarms, the FC-Series camera Alarm Source Device ID is set to 0.
The Alarm Source Device Type is chosen from a pull down menu; not
all options are available for a specific camera or installation.
When the alarm source is Video Analytics or Radiometric IR, the Alarm
ID corresponds to the area or spot id (0-3), as configured in the Setup
menu. The Alarm ID is set sequentially during the setup for each alarm
source. Refer to
Monitoring Setup (FC-Series R camera only), pg.
When the alarm source is from the internal GPIO Input, the Input ID is
set to 0 (recall the input is IO 0 and the output is IO 1).
427-0073-12-12 Version 120
3-27).
Video Analytics Setup, pg. 3-4
May 2015
Services Menu, pg.
2-12). See also the Media Browser
and
Temperature
3-10.
Set Enable
to Yes
3-23
Advertisement
Table of Contents
