Table of Contents
Advertisement
2
Basic Operation and Configuration
LAN Settings: The LAN Settings page can be used to set the hostname, default gateway, and IP
address for the camera. A more descriptive Friendly Name (used by FSM) can be set from the
Product Info page with the admin login. The default IP Address mode is static; the mode can also be
set to DHCP.
When the LAN settings are changed and the Save
button is clicked, a pop-up message will appear to
indicate the network interface must be restarted.
Once the IP address of the camera is changed, the PC
may no longer be on the same network and therefore
may not be able to access the camera until the IP
address on the PC is changed also. For that reason, it
makes sense to change the IP address after making
other configuration changes.
To reset the IP address to the factory default using a
loopback connector, refer to
Settings, pg.
Note
The IP address is temporarily displayed on the analog video after the camera finishes its boot cycle.
If the camera IP address is unknown, it is useful to reboot the camera and watch for the IP Address
information after the camera boots up (usually about 90 seconds after power is applied).
427-0073-12-12 Version 120
Restoring the Factory
3-29.
May 2015
2-11
Advertisement
Table of Contents
