Table of Contents
Advertisement
3
Advanced Configuration
3.1.3.2Using FSM to set Analytics Properties
If necessary, refer to section 2.3.4 "Using FSM" on page 2-7 for information about installing and
running FSM. Ensure the video can be displayed in one of the video walls and the icon for the camera
in the Sensor Panel shows as a green joystick, indicating the camera is connected and the user has
control of the camera.
The method for creating the analytics areas or regions with FSM is similar to the method described for
using a web browser in section 3.1.2 "Video Analytics Setup" on page 3-4. However there are some
differences with how the areas are created and with how the near and far parameters are set.
In FSM, the analytics areas are configured using the
Advanced Sensors Control panel, which is available
from the View menu at the top of the screen. From
the pull-down menu, select the "Video Source 0
[uFLIRish Bullet Video]" item.
When the window appears, select the Analytics tab
to display the advanced controls.
Click on the image
and select Create
Region to begin
creating the region.
Then click in other
locations on the
image up to 9 more
times to define the
polygon.
Double-click the
last point to finish
creating the region.
Ensure the Analytics Enable check box is checked, and set the sensitivity with the slider bar at the top
right of the window.
427-0073-12-12 Version 120
Anaytics Tab
May 2015
3-8
Advertisement
Table of Contents
