Subscribe to Our Youtube Channel
Related Manuals for Topp Music Gear MX Series
Summary of Contents for Topp Music Gear MX Series
- Page 2 MX SERIES U S E R' S MA N U A L U S E R ' S M A N U A L MX SERIES MIXER NF03165-1.0...
- Page 3 M X S E R I E S M X S E R I E S SAFETY RELATED SYMBOLS NOTE Protective Ground Before turning the unit ON, make sure that it is connected to Ground. This is to prevent the risk of electric shock. Never cut internal or external Ground wires.
-
Page 4: Table Of Contents
M X S E R I E S M X S E R I E S GUARANTEE TABLE OF CONTENTS Topp Pro guarantees the normal operation of the product against any defect of manufacture 1. INTRODUCTION..................1 and/or vice of material, by the term of (12) months, counted as of the date of purchase on the part of the user, committing itself to repair or to change, to its election, without position some, any 2. -
Page 5: Introduction
M X S E R I E S INTRODUCTION TECHNICAL SPECIFICATION Thank you for purchasing the MX series mixing console. This series include four mixers Model Number MX Series Mixer (MX.5/MX.6/MX.10/MX.12). There is 2-band EQ on all mono channels (MX.5), and... - Page 6 M X S E R I E S M X S E R I E S HOOKUP DIAGRAM Small Club Gig Mono in/Stereo out Reverb BLOCK DIAGRAM Microphones 1 and 2 MX.12 Headphones Active Speakers Drum Machine DAT Recorder Keyboard CD Player Computer Set-up Microphones...
-
Page 7: Control Elements
0 dB to 50dB. EQUALIZATION The MX series has 3-band EQ on all mono channels (except MX.5 has 2-band EQ). And only the MX.6 has EQ controls on stereo channels. All bands provide up to 15 dB boost or cut. - Page 8 M X S E R I E S MX SERI ES BLOCK DIAGRAM CONTROL ELEMENTS HIGH This is the treble control. You can use it to get rid of high frequency of the human voice. The MX.6 gain range goes from -15 dB to +15 dB with a centre frequency of 12 kHz. MID EQ (except MX.5) This control provides 15 dB boost or cut at 2.5 kHz.
- Page 9 M X S E R I E S M X S E R I E S CONTROL ELEMENTS BLOCK DIAGRAM PAN/BAL MX.5 Abbreviation of PANORAMA control for mono channels, for the stereo channels, always says, BALANCE control. You can adjust the stereo image of the signal via this control. For mono MIC/LINE channels, keep PAN control in centre position and your signal will be positioned in the middle of stage that is to say the mono signal appears equally in both sides.
-
Page 10: Note
M X S E R I E S M X S E R I E S WIRE CONNECTIONS CONTROL ELEMENTS Either the 1/4" TRS phone jack or XLR connector can be wired in balanced and unbalanced modes, TAPE TO MIX Switch which will be determined by the actual application status, please wire your system as the following Connect a CD or Tape Deck to the CD/TAPE inputs, and push down this switch to add the wiring examples:... - Page 11 M X S E R I E S M X S E R I E S CONTROL ELEMENTS INSTALLATION TIPS MAIN OUT 1- Speakers should be placed in a position that allows for unobstructe sound projection. In These 1/4" TRS jacks represent the end of the mixer chain, where your fully mixed stereo many instances is beneficial for speakers to be elevated on tripod stands to achieve signal enters the real world.
Need help?
Do you have a question about the MX Series and is the answer not in the manual?
Questions and answers