Table of Contents
Advertisement
1.
Release the ZIF connector (1) to which the sensor board cable is attached, and then disconnect the
sensor board cable from the system board.
2.
Detach the sensor board cable (2) from the display panel assembly. (The sensor board cable is attached
to the display panel assembly with double-sided adhesive.)
3.
Detach the sensor board (3) from the display panel assembly. (The sensor board is attached to the
display panel assembly with double-sided adhesive.)
4.
Remove the sensor board and cable.
Reverse this procedure to install the sensor board.
Display panel cable
NOTE:
The display panel cable is included in the Cable Kit, spare part number 802835-001.
Before removing the display panel cable, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and
then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the back cover (see
5.
Disconnect the battery cable from the system board (see
Remove the display panel cable:
28
Chapter 5 Removal and replacement procedures
Back cover on page
18).
Battery on page
19).
Advertisement
Table of Contents
