Display Panel Cable - HP Split 13 x 2 PC Maintenance And Service Manual

Display panel cable

NOTE:
The display panel cable is included in the Cable Kit, spare part number 736883-001. See
Cable Kit on page 21
Before removing the display panel cable, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the back cover (see
5.
Remove the tablet battery (see
Remove the display panel cable:
1. Release the adhesive strip (1) that secures the display panel cable connector to the
display assembly.
2. Use the display panel cable connector bar (2) to disconnect the display panel cable (3) from the
display panel.
3. Disconnect the display panel cable (4) from the system board.
4. Remove the docking panel cable board (5).
Reverse this procedure to install the display panel cable.
for more Cable Kit spare part information.
Back cover on page
Tablet battery on page
34).
36).
Removal and replacement procedures
55