D-Link DSL-1500G++ User Manual page 70

Attribute
Auto Start
Activate Line
CRCerrors
SEGAerrors
LOSWerrors
SNRLp1
SNRLp2
Atten Lp1
Atten Lp2
Physical Port
Port Speed
TxBurstSize
CACMode
Cbr_CPS
RvbrPCR_CPS
RbrPCR_CPS
VbrPCR_CPS
VbrSCR_CPS
Ubr_CPS
RingLength
VPIRange
VCIRange
DefaultPCR
DefaultMaxQueue
TrafficShaping
NiType
SnmpIfIndex
SnmpIfType
DSL-1500G++ User Manual
"True" - A Connection will be established at power up.
"False" - The modem will remain in Idle mode at power
up.
false – normal operation
true – reset DSP
cyclic redundancy check errors occured
segment anomaly
Loss of Sync Word error occured
Signal to Noise Ratio margin in loop 1
Signal to Noise Ratio margin in loop 2
A value between 0dB and 12dB that indicates the
transmit power attenuation in loop1
A value between 0dB and 12dB that indicates the
transmit power attenuation in loop2
A value between 0 and 14 that sets the Utopia Level 2
Utopia address
Specifies the maximum aggregate transmit speed for the
port, specified in cells/second.
Burst size (in cells) for unshaped traffic. See the ATM
Driver Tuning Guide (DO-008174-TC).
Call Access Control (CAC) mode.
Total allocated CBR bandwidth in cells per second (this
is used by CAC).
Bandwidth allocated for rt-VBR PCR.
Bandwidth allocated for VBR PCR.
Bandwidth allocated for VBR PCR.
Bandwidth allocated for VBR SCR.
Total UBR bandwidth.
Size of timing ring for shaped traffic (determines
maximum delay for a channel).
Number of bits of supported VPI range. The default
value of twelve indicates a VPI range of 0-4095.
Number of bits of supported VCI range. The default
value of sixteen indicates a VCI range of 1-65535.
Application code may open a channel with a VCI in
range 1 = vci < VCIRange.
Default PCR in cells/second of channels on this port
(only relevant for shaped traffic).
Default buffer queue depth of channels on this port.
Whether traffic-shaping is enabled on the port.
Whether received cell headers are treated as having
8-bit VPI (uni) or 12-bit VPI (nni).
Unique value for interface (assigned by support library).
IANAifType MIB-II interface type code.
- 70 -
Value Default
True
false
0