Parts Lists - WAGNER 0418B ProjectPro 117 Owner's Manual

WAGNER Project Pro 117 - 0418B
Figure 18 - Cleaning the Inlet Valve
Cleaning or servicing the inlet valve may be required if
i
the unit has priming problems. Priming problems may
be prevented by properly cleaning the sprayer and
following the long-term storage steps.
1. Remove the suction hose and return tube.
2. Remove the inlet valve unit (a) from the basic unit with an
adjustable wrench. Visually inspect the inside and outside
of the inlet valve assembly. Clean any paint residue with the
appropriate cleaning solution.
3. Replace inlet valve assembly by screwing it into the sprayer.

Parts Lists

Figure 19 - Suction Set
Part # Description
2306606 Suction set assembly ........................................... 1
Figure 20 - Spray Gun/Spray Hose
Item Part # Description
1 0418717 Gun assembly (without nozzle) ....................... 1
2 0418708 Tip, L ........................................................................... 1
3 0418713 Filter, L - XXL+ (white) ......................................... 2
4 2351007 Spray hose, 10m, yellow ..................................... 1
Accessories
Part # Description
0418705 Spray tip, XS .....................Water-soluble and solvent
0418706 Spray tip, S .......................Synthetic resin-based paints,
0418707 Spray tip, M ......................Enamel paints, undercoats,
0418708 Spray tip, L .......................Enamel paints, undercoats,
0418711 Filter, XS - S (red, 2 pack)
0418712 Filter, M (yellow, 2 pack)
0418713 Filter, L - XXL+ (white, 2 pack)
0418715 Pump section refurbishing kit (No. 5,6,7,8,9,10,11)
All spare parts listed above are wear parts, and are not covered
by warranty.
Quantity
Quantity
based enamels and paints, oils
and release agents
PVC paints
primers, fillers, indoor latex
paints and indoor emulsions
primers, fillers, indoor latex
paints and indoor emulsions,
anti-corrosive paints
19