Problem Solver - Tele System TS6208 User Manual

TELE System

6. Problem solver

PROBLEM
1. The receiver does not start / no LED
lights up on the front panel
2. No Video or Audio signal
3. The channel scan gives no results
4. The settings are not saved.
5. The remote control does not work.
6. You have forgotten the Password.
7. The event timer function doesn't work
properly.
9. The receiver does not interact with
the remote control buttons.
10. The receiver goes down into
standby mode automatically
8
POSSIBLE CAUSE
-The mains lead is not plugged in.
-The mains lead is plugged in but the
receiver still does not work.
-No signal or a poor signal.
-SCART cable or antenna cable not
connected properly.
-Audio volume low or zero.
-AV channel not selected on TV.
-Current channel is obsolete or stopped
temporarily.
-No antenna signal.
-Your antenna system
compliant with the digital terrestrial
signal.
-You have an active antenna.
-Setting changes are not confirmed
before quitting.
-The receiver is in Stand-by.
-The remote control is not being directed
towards the receiver.
-The remote control batteries are flat.
-The batteries have been inserted in the
wrong direction.
-The remote control has been dropped
and its internal components have been
damaged.
-The specific program transmits a wrong
time information.
-The receiver time has not been set
correctly
-The receiver is temporarily blocked.
-There is a problem with the remote
control.
- The Auto Standby function is active
-Make sure the mains lead is
properly plugged in.
- Unplug the mains lead and check it
for damage (risk of electric shock!).
-Check the SCART connection, the
antenna
quality.
-Make sure the TV and receiver
volumes are not set to zero.
-Make sure the AV channel is
selected on the TV (consult the TV
user manual).
-Change to a valid channel.
-Check for a signal using the
is not fully receiver menu.
-Ask for an antenna technician help.
-Check the "Antenna Setting" (refer
to chapt. 3, point 4).
-Before quitting a menu press the
Confirm button to save the changes.
-Press the STAND-BY button on the
front panel to check the receiver is
working properly.
-Make sure nothing is obstructing the
front panel.
-Change batteries.
-Check the battery polarities.
-Contact the local dealer and buy a
new remote control.
-The default password is 0-0-0-0
(four zeros). If you have changed
password consult this manual at
section 4.1.1.
- Set the time from the menu (see
section 4.3).
-Unplug the mains lead of the
receiver for at least one minute and
then plug it back in.
-Go to point 5 of this chapter.
- Disable the automatic power-down
function (see section 4.5).
REMEDY
installation and signal