Table of Contents
Advertisement
MAINTENANCE
60" MACHETE HEAD MOTOR PLATE ATTACHEMENT
Before installing the rods run two nuts on each end
of the rods down 2". Place a hardened Flatwasher
on each end. see FIGURE Mnt-B-0018.
Place the straights rods in the holes marked 1 thru
4. See FIGURE Mnt-B-0019.
Once the rods are in the holes through the Buck
Plate align the rods through the holes on the mount
plate and place the mount plate on top of the relief
block. The valve block bolts on top of the motor are
not eaqually spaced. Make sure the pockets align
accordingly. See FIGURE Mnt-B-0020.
MACHETE 01/05
Maintenance Section 4-10
© 2005 Alamo Group Inc.
Advertisement
Table of Contents
