Hydraulic Oil, Filters, And Components - Alamo Machete 02968915C Operator's Manual

MAINTENANCE
If possible, it is best to check the spindle oil level after the machine has been operated. This will allow the oil to
flow easier.
Position the head vertical as shown in Figure MntP-B-0002. Remove the breather/check plug from the square
portion of the spindle housing. Remove the fill plug and fill with NLGI 000 grease (Alamo P/N 00765444) until
it comes out of the breather/check hole in the square portion of the spindle housing. See Figure MntP-B-
0003. Replace breather/check plug and fill plug.
FML 100 HEAD:
Position the head horizontal and lower to the ground. Remove the filler/breather from the top of the spindle
housing. Remove the check plug from the side of the housing. Fill the spindle through the top hole until it
comes out of the side check hole. Replace the filler/breather and check plug.

HYDRAULIC OIL, FILTERS, AND COMPONENTS

Filters and Oil - Change the Pressure Filter after the first 200 hours of operation. Change the filter again at 800
hours; then, change the oil and filters at 1600 hours. After that, continue to change the filter every 800 hours
and the oil every 1600 hours. Use AW ISO VG 100 Tractor Hydraulic Fluid.
If the Mower head destrokes (cuts off or loses power) it may be an indication that the Pressure Filter needs to
be changed
Change Filter element of filter on pressure port of valve when indicator is red in color. Indicator can be found on
top of the filter housing. Replacement Filter element Part No. is 02976067.
Keep all hoses and adapters tight. Repair any leaks immediately. Do not overtighten hose end fittings.
Tighten to specifications only. (See Chart Below)
Check the hydraulic oil level daily.
MACHETE 01/05 Maintenance Section 4-3
© 2005 Alamo Group Inc.