Signal Adjust; Color/Frame Window; Board; Color - Sony SRX-T423 Operating Instructions Manual

Signal Adjust

Adjusts the picture quality of the input signal.
Clicking increases the setting value, and
decreases it.
Clicking the [RESET] button resets the following four
settings to the factory preset values.
Contrast: Adjusts the picture contrast. The higher the
setting, the greater the contrast.
Brightness: Adjusts the picture brightness. The higher the
setting, the brighter the picture.
Color: Adjusts the color intensity. The higher the setting,
the greater the intensity.
Sharpness: Adjusts the picture sharpness. The higher the
setting, the sharper the picture. The lower the setting,
the softer the picture.
60

COLOR/FRAME Window

COLOR/FRAME Window
The COLOR/FRAME window is used to adjust the input
signal.
When [Quad-screen Mode] is selected with the INPUT
SELECT radio buttons, the items can be independently
adjusted for each input channel displayed on the screen.

Board

Shows the input board installed in the relative input board
slot of the projector.

Color

Adjusts the items so that you can obtain precise color
reproduction.
If the color of an image is not correct, check the setting of
[Color Space] first.
Select the setting from the drop-down list displayed by
clicking .
Color Space: Selects the color gamut.
sRGB(709): Select when projecting a normal high-
definition signal or RGB signal.
DCDM: Select when projecting a signal source using
the Minimum D-Cinema Color Gamut defined by the
DCI Specifications Book/Version 1.0.
CIE XYZ: Select when projecting an XYZ signal
from LKRI-003.
Note
Set [Signal Mode] of [Input Source] in the PICTURE
CONTROL window to [RGB FULL].