Table of Contents
Advertisement
Projecting
Projecting the Picture
Use a computer in which the SRX Controller is installed to
project the picture on the screen.
1
Program Launcher screen
3
Control Function Menu window
6
7
INSTALLATION window
8,10
LAMP indicator
MAIN indicator
1
Set the power switch on the rear of the projector to the
on position (:).
The MAIN and LAMP indicators light red and the
projector goes into standby mode.
2
Start your computer and double-click the
the SRX Controller in the desktop window.
The Program Launcher screen appears.
3
Double-click the projector you want to operate.
The SRX Controller starts and the Control Function
Menu window appears.
Note
When you connect the projectors to the computer via a
network, you can also select the projector you want to
operate by specifying the IP address of the projector. If
4
connection is made via the RS-232C connector on the
projector, specify the RS-232C port number of the
computer.
For details, see "Changing the Connection Mode" on
page 53.
4
Click the [POWER ON ?] button to turn on the
projector.
The MAIN and LAMP indicators light green.
3
Chapter
9
Projecting the Picture
icon of
55
Advertisement
Table of Contents
