Master Forge RT2417S Use Manual page 35

TROUBlESHOOTINg
Problem
Low heat, natural
gas.
Low heat,
LP gas.
Low heat
generated with
knob in "HIGH"
position.
Sudden drop in
gas flow or low
flame.
Possible Cause
Gas pressure is significantly
affected by gas line and
length of gas line from
house gas line.
The propane regulator
assembly incorporates an
excess flow device designed
to supply the grill with
sufficient gas flow. Rapid
changes in pressure can
trigger the excess flow
device, providing a low
flame and low temperature.
1. Low heat is found in
natural gas models.
2. Ports are blocked.
3. LP tank has run out.
1. Out of gas.
2. Excess flow valve tripped.
3. Vapor lock at coupling nut/
LP cylinder connection.
Corrective Action
Check your gas line and make corrections by
followong the chart below.
From House to Grill
Distance
Up to 25 ft.
26 - 50 ft.
51 - 100 ft.
Please follow these instructions:
1. Make sure all burners are "OFF".
2. Open the tank valve and wait 5 minutes.
3. Light the burner one at a time following the
lighting instructions listed on the door liner.
1. This model is set for 7 in. natural gas usage.
Please check your natural gas supply system
to have correct gas pressure. Regulator is
not needed for NG model. Check the orifice if
you installed NG nozzles.
2. Clear ports of any obstructions.
3. Refill the LP tank.
1. Check for gas in LP cylinder.
2. Turn off knobs, wait 30 seconds and light
grill. If flames are still low, turn off knobs
and LP cylinder valve. Disconnect regulator.
Reconnect regulator and leak test. Turn on
LP cylinder valve, wait 30 seconds and then
light grill.
3. Turn off knobs and LP cylinder valve.
Disconnect coupling nut from cylinder.
Reconnect and retry.
35
Tubing Size
3/8 in. diameter
1/2 in. diameter
1/3 in. of run 1/2 in.
2/3 in. of run 3/4 in.
Lowes.com/masterforge