1. Manuals
  2. Brands
  3. Evo Manuals
  4. Cooktop
  5. Affinity 30Ge
  6. Owners & installation manual

Evo Affinity 30Ge Owners & Installation Manual

Hide thumbs Also See for Affinity 30Ge:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Owner's Manual
®
the natural way to cook
®
This appliance and its individual shutoff valve must be
disconnected from the gas supply piping system during
any pressure testing of system at test pressures in
excess of 1/2 PSI (3.5kPa).
This appliance, when installed, must be electrically grounded in accordance with local codes,
or in the absence of local codes, with the National ELectrical Code, ANSI/NFPA70,
Certification: ANSI Z83.11b-2009/CSA 1.8B-2009. OMNI Report # 0141GM004S
Part #: Commercial models: 10-0050-NG | 10-0050-LP, Residential models: 10-0051-NG | 10-0051-LP,
Doc: OM-C&R-30Ge 09/2014
Copyright © 2015
Evo Affinity 30Ge
Electronically-Controlled Gas Cooktop
For Indoor Use Only
or the Canadian Electrical Code, CSA C22.2, as applicable.
Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA
Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com
OWNER & INSTALLATION MANUAL
This appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
valve during any pressures testing of the gas supply
system at test pressures equal to or less than 1/2 PSI
(3.5kPa).
A f f i n i t y 3 0 G e
C o o k t o p

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Affinity 30Ge and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Evo Affinity 30Ge

Summary of Contents for Evo Affinity 30Ge

  • Page 1 Part #: Commercial models: 10-0050-NG | 10-0050-LP, Residential models: 10-0051-NG | 10-0051-LP, Doc: OM-C&R-30Ge 09/2014 Copyright © 2015 Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 2 Be sure to read and carefully follow personal injury and / or property damage. all of the messages. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 3 Model #_______________________________ Serial # _________________________________ Date Purchased ________________________ Location Purchased _______________________ Date Installed __________________________ Location Installed _________________________ Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 4 DURING THE FIRST FEW HOURS OF OPERATION IT IS NORMAL FOR OILS USED IN THE MANUFACTURING PROCESS TO BURN OFF AND GIVE AN ODOR OR PETROLEUM SMOKE. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 5 The maximum liability to Evo, Incorporated in any event, shall not exceed the purchase price of the product paid by the original consumer-purchaser.
  • Page 6 One Year from the original date of purchase from Evo, Inc. This warranty is for the benefit of the original use purchaser and is non-transferable.

  • Page 7: Table Of Contents

    INSTALL ELECTRICAL TC CONNECTIONS TO COOK SURFACE 17-18 INSTALL COOK SURFACE AND TIGHTEN FASTENERS 19-20 CONNECT ELECTRICAL AND GAS LINES CHECK INSTALLATION Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...

  • Page 8: Unpack Cooktop Components

    Ignition components are exposed during uncrating and installation. Use caution and do not alter factory set positions. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...

  • Page 9: Prepare Countertop For Installation

    Evo Affinity 30Ge Cooktop to a metal, stone or wood countertop surface. Cabinet layout and construction may vary. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 10 OPENING IN COUNTERTOP FRONT containers. STEP 2: Mark the finished position of the Evo Affinity 30Ge drip pan on the countertop using the dimensions shown. The circular dimension of 18-1/8” is the diameter of the drip pan to the outside flange material thickness (located to the inside of the half-rolled bead edge). The drip pan cutout must be made precisely to these dimensions (or at a maximum +1/16”) so...
  • Page 11 Also ensure allowance for the countertop overhang as shown on the SIDE VIEW (see next page). When you have confirmed the position is correct, cut the countertop and substrate. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 12 Example of 3/8” tile with substrate for a minimum 3 cm overall. Make sure you allow for the countertop overhang as shown. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 13 30Ge if desired. STEP 3: Construct a bay for the Evo unit with your chosen cabinet system. Position and fasten the supplied mounting brackets 7.65” below the finished countertop surface. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA...

  • Page 14: Insert Chassis In Countertop

    Use supplied 1/4” fasteners to bolt chassis to angle brackets. STEP 4: Slide the Affinity 30Ge chassis into the countertop so it rests on top of the installed brackets. Bolt unit to angle brackets using supplied 1/4” x 20 fasteners from underside.

  • Page 15: Install Drip Pan

    From the inside of the skirt, use each of the three latches to pull the drip pan down into the counter. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...

  • Page 16: Install Drip Pan Gasket

    STEP 6: Secure drip pan to chassis using access slot (A). Rewrap drip pan gasket around top of drip tray and secure (B). Ensure seal under drip pan edge is touching countertop(C). Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...

  • Page 17: Install Electrical Tc Connections To Cook Surface

    Outer Zone TC (Thermal Couple Temperature Detector) Used To Electrically Monitor Cook Surface Temperatures At Inner And Outer Zones. The Affinity 30Ge uses K-Value TC’s. The numbers show TC threaded stud locations for attaching TC wires. Each TC stud location has a corresponding numbered TC connection wire located at a respective location on the heat shield under the burners.
  • Page 18 TC wire back through the heat shield so there is a direct and straight path from the cook surface connection down through the heat shield. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...

  • Page 19: Install Cook Surface And Tighten Fasteners

    (B) and the rear bullet secures in the chassis slot (C) . Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 20 STEP 9: Open both waste doors and tighten nyloc nut on end of j-hook located at inside rear of each waste door. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...

  • Page 21: Connect Electrical And Gas Lines

    INSTALLATION SHOULD CONFORM TO THE NATIONAL ELECTRIC CODE AND ALL HIGH VOLTAGE LOCAL ELECTRIC AND GAS RULES AND REGULATIONS. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...

  • Page 22: Check Installation

    INSTALLATION IS COMPLETE Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 23 When MODE is held for 4 seconds, the temperature display units change from Fahrenheit (°F) to Celsius (°C). Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 24 Because the cook surface temperatures are electronically monitored to maintain a Set temperature, surface temperature recovery is very fast, providing a wide range of surface temperature adjustment and control. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 25 Spillover debris and liquids can be hot and cause burns, and/or damage to the internal operation of the grill. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
  • Page 26 To condition the Evo cook surface you should use the grill cleaning kit supplied with your grill. The grill cleaning kit contains a blue grill pad handle, grill cleaning screens, and grill grey polishing pads. Use the polishing pad after the grill cleaning pads to achieve a smooth cooking surface for the most delicate foods and applications.
  • Page 27 A f f i n i t y 3 0 G e PART #: 10-0050 NG / 10-0050 LP Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...

  • Page 28: Gas Regulator

    A f f i n i t y 3 0 G e GAS REGULATOR The Affinity 30Ge cooktop uses a Robert Shaw 4080 Series gas regulator installed under the access panel on the right rear quarter of the chassis box. Listed below are the manufacturer specifications.
  • Page 29 To access the TCU, remove the lower front panel on the chassis and gently pivot the TCU bracket from underneath the chassis. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...

Table of Contents