Do not obstruct the fl ow of combustion and ventilation air, including ventilation of cylinder enclosures, if applicable. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Page 4
DURING THE FIRST FEW HOURS OF OPERATION IT IS NORMAL FOR OILS USED IN THE MANUFACTURING PROCESS TO BURN OFF AND GIVE AN ODOR OR PETROLEUM SMOKE. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Page 5
This appliance is not intended to be installed in or on boats, and is not intended to be installed in or on recreational vehicles. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Page 6
The maximum liability to Evo, Incorporated in any event, shall not exceed the purchase price of the product paid by the original consumer-purchaser.
Page 7
One Year from the original date of purchase from Evo, Inc. This warranty is for the benefi t of the original use purchaser and is non-transferable.
INSTALL COOK SURFACE AND TIGHTEN FASTENERS 18-20 CONNECT GAS & CHECK FOR LEAKS 21-25 CHECK INSTALLATION & TEST EVO Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Page 9
Ignition components are exposed during uncrating and installation. Use caution and do not alter factory set positions. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Minimum 3” clearance required under unit venting to 22 sq/in of combustible air. The minimum environmental temperature for safe use of the Evo Affi nity 30G should not go below 30 degrees F (-1 degree C). CLEARANCE TO COMBUSTIBLE CONSTRUCTION FROM CHASSIS...
704.85mm OPENING IN COUNTERTOP FRONT STEP 2: Mark the fi nished position of the Evo Affi nity 30G drip pan on the countertop using the dimensions shown. The circular dimension of 18-1/8” is the diameter of the drip pan to the outside fl...
Page 12
Also ensure allowance for the countertop overhang as shown on the SIDE VIEW (see next page). When you have confi rmed the position is correct, cut the countertop and substrate. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Example of 3/8” tile with substrate for a minimum 3 cm (1-1/5”) overall. Make sure you allow for the countertop overhang as shown. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
30G if desired. STEP 3: Construct a bay for the Evo unit with your chosen cabinet system. Position and fasten the supplied mounting brackets 7.65” below the fi nished countertop surface. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA...
Gas Installation must be done by a licensed professional in accordance with local guidelines once unit has been completely installed. Refer to pages 21- 25 for further instructions. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Page 16
From the inside of the skirt, use each of the three latches to pull the drip pan down into the counter. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Page 17
STEP 6: Secure drip pan to chassis using access slot (A). Rewrap drip pan gasket around top of drip tray and secure (B). Ensure seal under drip pan edge is touching countertop(C). Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Refer to pages 21-25 for specifi c instructions regarding LP and NG connections, checking for gas leaks and recognizing abnormal gas operation (page 30). Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Page 22
If it is evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior to the unit being put into operation. Regulator and hose assembly can be purchased from Evo by calling 866-626-1802 or from a local gas supply company. Specifi cations for these parts are: •...
Page 23
CAN/CSA B339. If the above information is not followed exactly, a fi re causing death or serious injury may occur. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Page 24
Note: All factory-made connections have been thoroughly checked for gas leaks. The burners and ignition system has been fl ame tested. As a safety precaution, we recommend you recheck all fi ttings for leaks before using your Evo grill. Shipping and handling may loosen or damage a gas fi tting.
Page 25
Note: All factory-made connections have been thoroughly checked for gas leaks. The burners and ignition system has been fl ame tested. As a safety precaution, we recommend you recheck all fi ttings for leaks before using your Evo cooktop. Shipping and handling may loosen or damage a gas fi tting.
GAS CONNECTION HOOKED UP PROPERLY 21-25 Check for gas leaks. Check for proper operation. INSTALLATION IS COMPLETE Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Spillover debris and liquids can be hot and cause burns, and/or damage to the internal operation of the grill. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
LIGHTING INSTRUCTIONS BEFORE EACH USE: Inspect gas hose under unit. If it is evident there is excessive abrasion or wear, or the hose is cut, please contact Evo for a replacement hose. See page 22 for further instructions. Electronic Ignitor Lighting Procedure: 1.
Remove cooking surface and drip pan to access valve cover located just above center control knob. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA Phone 503.626.1802 | Fax 503.213.5869 | www.evoamerica.com | support@evoamerica.com...
Place the cover back on. Replace screw for battery cover. 5. If the ignitor is still not working, contact Evo Customer Support for an ignitor replacement. Evo, Inc. | 8140 SW Nimbus Ave., Bldg 5 | Beaverton, Oregon 97008 USA...
Page 33
To condition the Evo cook surface you should use the grill cleaning kit supplied with your grill. The grill cleaning kit contains a blue grill pad handle, grill cleaning screens, and grill grey polishing pads. Use the polishing pad after the grill cleaning pads to achieve a smooth cooking surface for the most delicate foods and applications.
Need help?
Do you have a question about the Affinity 30G and is the answer not in the manual?
Questions and answers