Glowing Ember Placement; Led's - Heat & Glo TRUE-36C Owner's Manual

F. Glowing Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Embers CANNOT be placed directly over ports. Care
should be taken not to cover the lighting trail of ports
(from back to front).
• Place dime-size pieces of Glowing Embers® just in front
of the port trail, but not on or in between the ports (see
Figure 14.5). Care should be taken so that the ports are
not covered. Failure to follow this procedure will likely
cause lighting and sooting problems.
• Save the remaining ember materials for use during
appliance servicing. The embers provided should be
enough for 3 to 5 applications.
GLOWING EMBERS GLOWING EMBERS
Figure 14.5. Location of Glowing Embers
52
Heat & Glo • TRUE-36, TRUE-42 • 2281-900 Rev. C • 5/12
G. LED's
LED's are factory installed. No additional set up or acti-
vation required.
• See section 3.A for maintenance and bulb
replacement.