Installing The Upper Handle; Installing The Wheel Clutch Cable Ends - Toro Power Max 38624 Operator's Manual

1. Installing the Upper Handle

4 Handle bolts
4 Curved washers
4 Locknuts
Procedure
Note: Do not remove the rubber band on the cables
until you have installed the upper handle.
1. Lift and rotate the upper handle and position it over
the lower handle (Figure 3).
Important: Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables and the wire for the
headlight are not pinched between the handle
sections.
1. Cables
2. Secure the upper handle with 4 handle bolts,
4 curved washers, and 4 locknuts from the loose
parts bag (Figure 4).
Figure 3
Figure 4
2. Installing the Wheel Clutch
Cable Ends
Procedure
Models 38634, 38644, and 38654 only
1. Unwrap the cable ends from the lower handle
(Figure 5).
2. Route either the left or right cable end over the lower
handle and insert the cable end into the hole in the
corresponding wheel clutch lever (Figure 6).
1. Wheel clutch lever
3. Remove the nut and washer from the handle, attach
the cable clamp on the cable to the handle, install
the washer and the nut, and hand tighten the nut
(Figure 7).
8
Figure 5
Figure 6