Adjusting The Discharge Chute Latch; Replacing The Drive Belts; Replacing The Headlight Bulb - Toro Power Max 38624 Operator's Manual

Adjusting the Discharge Chute
Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge chute latch.
1. Remove the fastener on the gear cover (Figure 58),
lift the front of the cover up, and slide it back and
out of the way.
2. Loosen the bolt on the cable clamp (Figure 59).
1. Cable conduit
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (Figure 59 and Figure 60).
1. Discharge chute latch
Figure 58
Figure 59
2. Cable clamp
Figure 60
2. Gear teeth
Note: The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 60).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, go
to www.Toro.com for additional service information or
have an Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 892 16W halogen light bulb. Do not touch
the bulb with your hands or allow dirt or moisture to
come into contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 61).
2. Turn the base of the bulb counterclockwise until it
stops (Figure 62).
3. Remove the bulb straight out from the back of the
headlight (Figure 63).
26
Figure 61
Figure 62