What To Do If - Electrolux EOC5440AO User Manual

2
B
Installing the door and the glass
panels
When the cleaning is completed, install
the glass panels and the oven door. Do

11. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
The appliance does not
heat up.
The appliance does not
heat up.
The appliance does not
heat up.
A
1
Problem
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
3. Close the oven door to the first open-
ing position (approximately 70° angle).
A
4. Hold the door with one hand on each
side and pull it away from the appli-
ance at an up angle.
5. Put the door with the outer side
down on a soft cloth on a stable sur-
face. This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
7. Pull the door trim to the front to re-
move it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
the above steps in the opposite se-
quence. Install the smaller panel first, then
the larger.
Possible cause
The appliance is deacti-
vated.
The clock is not set.
The necessary settings
are not set.
ENGLISH
Remedy
Activate the appliance.
Set the clock. Refer to
"Setting the clock".
Make sure that the set-
tings are correct.
27