Table of Contents
Advertisement
28 www.electrolux.com
The appliance does not
heat up.
The appliance does not
heat up.
The lamp does not oper-
ate.
The pyrolytic cleaning
does not operate (the
time display shows "C3").
The display shows
"F102".
The display shows an er-
ror code that is not on
this list.
If you cannot find a solution to the prob-
lem yourself, contact your dealer or the
service centre.
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
12. INSTALLATION
WARNING!
Refer to the Safety chapters.
Problem
Possible cause
The automatic cut-out is
activated.
The fuse is released.
The lamp is defective.
You did not fully close the
door, or the door lock is
defective.
• You did not fully close
the door.
• The door lock is defec-
tive.
There is an electrical fault. • Deactivate the appli-
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance cavity.
Remedy
Refer to "Automatic
switch-off".
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact
a qualified electrician.
Replace the lamp.
Fully close the door.
• Fully close the door.
• Deactivate the appli-
ance with the house
fuse or the safety
switch in the fuse box
and activate it again.
• If the display shows
"F102" again, contact
the Customer Care De-
partment.
ance with the house
fuse or the safety
switch in the fuse box
and activate it again.
• If the display shows the
error code again, con-
tact the Customer Care
Department.
.........................................
.........................................
.........................................
The built-in unit must meet the
stability requirements of DIN
68930.
Advertisement
Table of Contents
