Kenmore Elite 795.7802 Series Use & Care Manual page 23

11. Reinstall the hinge pin insert (1), the hinge pin brackets
(2) and screws (3) on the bottom left side of the door.
14. Using a 13/32 in. socket wrench with a 2 in. extension
and a screwdriver, tighten the two bolts and a screw,
and attach the bottom hinge on left side of the flange.
15. Attach the hinge pin using a 1/4 in. socket wrench.
12. On the top part of the door, you will find a cap (1) and
a pivot (2). Remove it with a fiat head screwdriver and
install it on the opposite side ( the cap stays on the
right and the pivot on the left).
_(2)
(_)
f_
Bottom Hinge Pin "'_
16. With a flat-head screwdriver, carefully pry off and
remove the cover over the bolt holes on the left side of
refrigerator.
13. Remove the decorative caps on the bottom of the
refrigerator housing. You will need these holes for the
Bottom Hinge.
Decorative Cap
1Z Remove the outer lower decorative screw from
the flange on the frame between the freezer and
refrigerator doors. (You will need this hole for the
middle hinge bracket.)
23
1 MFL67855601 Eng.indd 23 2013.7.25 8:51:43AM