Kenmore Elite 795.7802 Series Use & Care Manual page 15

Reinstalllng the Refrigerator Door
1 Make sure that the plastic sleeve is inserted in the
bottom of the door. Lower the door onto the middle
hinge pin as shown in the figure.
2 Align the door with the cabinet.
HOW TO REMOVE THE FREEZER DOOR
(For Freezer Swing Models)
NOTE:
Before removing the freezer door, make sure you
completely remove the refrigerator door.
Use a 1/4 in. hex socket wrench to loosen and remove
the hinge pin from the middle hinge bracket. Use a
10 mm or 13/32 in. socket wrench to remove the two
bolts. Remove the screw and set the middle hinge
bracket and other parts aside. Remove the washer.
Middle Hinge _ IScre w
Middle
Hinge
Pin
3 Line up the top hinge with the holes in the top of the
refrigerator. Insert and tighten the three bolts in the
hinge.
2 Carefully tilt up the freezer door. Remove and place it
on a non-scratching surface.
t
Bottom Hinge Pin
HOW TO iNSTALL THE FREEZER DOOR
4 Replace the cover. Insert and tighten the cover screws
(2).
Place the freezer door down on the bottom hinge pin.
Bottom Hinge Pin
15
2 Replace the washer and the middle
hinge bracket.
Use a 10 mm or 13/32 in. socket wrench to insert and
tighten the bolts. Insert the screw. Reattach the middle
hinge pin using a 1/4 in. socket wrench.
Screw\_l _
, /
Middle Hinge _ Middle Hinge Pin
.... _ __J i
_¢_ _:_. Washer
1 MFL67855601 Eng.indd 15 2013.7.25 8:51:27AM