Necessary Deviation Adjustment Item For Each Signaling And Mode - Kenwood NX-200 K2 Service Manual

Vhf digital transceiver

Table of Contents

NX-200

Item

Panel tuning mode

15. BATT

1) Adj item: [BATT]

detection

Adjust: [✳✳✳]

writing

PTT: ON

16. BATT

[Panel test mode]

detection

1) CH-Sig: 1-1

check

BATT terminal

voltage: 6.0V while

transmitting

■ Necessary Deviation adjustment item for each signaling and mode

The following shows the necessary adjustment items for each signaling deviation. Please read the following table like the following example. In the

case of the signaling "QT (Wide)", this signaling is composed of three elements [Balance, Maximum Deviation (Analog Wide) and QT Deviation (Wide)].

Please adjust Balance and Maximum Deviation (Analog Wide) before adjusting QT Deviation (Wide).

Mode

Signaling

Step1. Balance adjust

Audio

Step2. Maximum Deviation (Analog Wide)

Step1. Balance adjust

Step2. Maximum Deviation (Analog Wide)

Step3. QT Deviation (Wide)

Step1. Balance adjust

DQT

Step2. Maximum Deviation (Analog Wide)

Step3. DQT Deviation (Wide)

Step1. Balance adjust

LTR

Step2. Maximum Deviation (Analog Wide)

Analog

Step3. LTR Deviation (Wide)

Step1. Balance adjust

DTMF

Step2. Maximum Deviation (Analog Wide)

Step3. DTMF Deviation (Wide)

Step1. Balance adjust

Step2. Maximum Deviation (Analog Wide)

2TONE

Step3. Single Tone Deviation (Analog

Wide)

Step1. Balance adjust

MSK

Step2. Maximum Deviation (Analog Wide)

(FleetSync)

Step3. MSK Deviation (Analog Wide)

ADJUSTMENT

Condition

PC test mode

equipment

1) Adj item:[Battery

Power

Warning Level]

meter

PTT: Press

DVM

[Transmit] button.

1) Test Channel

Channel: 1

Test Signaling

Mode: Analog

Signaling: 1

BATT terminal

voltage: 6.0V while

transmitting

Wide

Step1. Balance adjust