System Set-Up; Realignment; Modes - Kenwood NX-200 K2 Service Manual

Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
NO
Are you using the speaker microphone?
NO
Are you using the voice guide & storage unit?
NO
Delivery

1. Modes

User mode
Panel test mode
PC mode
Firmware
programming mode
Clone mode
Firmware version information

SYSTEM SET-UP

Frequency range (MHz)
A personal computer, programming interface (KPG-36/36A),
USB adapter(KCT-53U), and programming software (KPG-111D)
are required for programming.
(The frequency, and signaling data are programmed for the transceiver.)
YES
YES
KMC-25/KMC-41/KMC-42W
GPS speaker microphone
YES

REALIGNMENT

Panel tuning mode
Data programming mode
PC tuning mode
PC test mode
RF power
TX/RX 136~174 5W
TX/RX 136~174 5W
KRA-22 or KRA-26
Optional antenna
(Option)
Speaker microphone
or
KMC-38GPS
(Option)
VGS-1 See page 7.
(Option)
Mode
User mode
Panel test mode
Panel tuning mode
PC mode
Data programming
mode
PC test mode
Firmware program-
ming mode
Clone mode
Firmware version
information
NX-200
Type DTMF keypad
NX-200 K No
NX-200 K2 Yes
Function
For normal use.
Used by the dealer to check the fundamen-
tal characteristics.
Used by the dealer to tune the transceiver.
Used for communication between the trans-
ceiver and PC.
Used to read and write frequency data and
other features to and from the transceiver.
Used to check the transceiver using the PC.
This feature is included in the FPU.
See pages 45 to 57.
Used when changing the main program of
the fl ash memory.
Used to transfer programming data from
one transceiver to another.
Used to confi rm the internal fi rmware ver-
sion.
3