gledhill BoilerMate BP Installation & Service Manual page 8

DESIGN
Connection Details/Dimensions For Top Of Unit
330 - Open Vent
370 - Cold Feed/Expansion
Connection Details/Dimensions For Bottom Of Unit
Boiler Flow and Return
130
370 - Mains Cold Water Inlet
485 - Hot Water Outlet
TECHNICAL DATA
580
560
Page 8
PLAN OF APPLIANCE CONNECTIONS
The BoilerMate BP units are supplied on an
installation base to allow the pipe runs to
connect to the appliance from any direction.
It is easier if all pipes protrude vertically in the
cut out area shown. Compression or push fi t
connections can be used. All pipe positions
are approximate and subject to a tolerance of
+/- 10mm in any direction. Space will also be
required for a 15mm cold water supply and a
22mm warning / overfl ow pipe.
Note: All dimensions are shown in mm and
are to the centre line of pipework.
Figure 5