On & Off Switch; Maintenance - Craftex CT126 Owner's Manual

CT126 Portable Dust Collector
Dust Collector On & Off
A. To turn dust collector on or off flip
the switch (1) to the desired
position.
B. There is a removable safety key (2)
in the tip of the switch that can be
removed when in the off position.
When the key is removed the dust
collector cannot be used.
Fig. 5
Note: Before connecting power cord to power source make sure that the switch is in
the off position.
Motor
Excessive dust in the motor could cause overheating. Every effort should be made to
prevent foreign material from entering the motor. When operated under conditions
likely to permit accumulation of dust and dirt within the motor, a visual inspection
should be made at frequent intervals. Accumulations of dry dust can usually be blown
out. Use a low-pressure air hose.
Caution: When performing the maintenance operation you should always wear safety
goggles and a dust mask. If the power cord becomes worn or frayed do not use the
dust collector.
Assembly
Fig. 5

Maintenance

9