Set Up - Kaiser Baas ALPHA User Manual

Set up

Charging
Plug your USB charging cable into a powered USB port
(wall adaptor not included). When connected correctly,
the USB plug will glow red. Connect your battery to the
USB charging cable. When charging correctly, the red light
should turn off. The red light will turn back on once charging
is complete (to avoid shortening battery life, do not remove
the battery from charge until charge sequence is complete).
Initial Assembly
Alpha Drone Feet
Insert the feet into the guide holes on the underside of
the Alpha Drone, in the allocated position. Push the Alpha
Drones feet into the underside of the body until the feet are
secure and flush against the body of the Alpha Drone.
Rotor blade guards
Insert rotor blade guards into guide holes in the allocated
position. Use the included screwdriver to secure the
propeller guards to the Alpha Drone, making sure not to
over-tighten.
Camera
Ensure that the camera cable is connected to the Alpha
Drone and insert the Micro SD card* into the allocated slot.
Battery
Slide the battery hatch out on the Alpha Drone and lift
gently to open. With the Alpha Drone turned off, insert the
battery into the opening with the cable end facing outward,
ready for connection. Plug the battery cable into the socket,
then close and lock the hatch by sliding gently back in place.
*
Micro SD card not included
13