Please read the included CASA flyer ‘Flying with control’. Learn and be aware of the laws and restrictions when flying your drone. Do not fly your Alpha Drone any closer than 5.5km to any airfield, or any closer than 30 metres to boats, buildings, people, or animals.
Keep both the Alpha Drone and the Transmitter away from water and other liquids. If water or other liquids come into contact with the Alpha Drone, battery, or Transmitter, do not operate. This product is not suitable for those 14 years and under.
Flight Equipment Alpha Drone and Remote Control Transmitter not shown below. 4 X Rotor blade guards 4 X Spare rotor blades 1 X Drone battery 2 X Landing feet 1 X USB battery charger 1 X Screwdriver...
Drone and insert the Micro SD card* into the allocated slot. Battery Slide the battery hatch out on the Alpha Drone and lift gently to open. With the Alpha Drone turned off, insert the battery into the opening with the cable end facing outward, ready for connection.
Be especially aware of things like power lines and nearby people and animals. If these hazards exist, DO NOT deploy your Alpha Drone and consider a new take-off location.
Page 15
The remote control has not connected to the Alpha Drone, try turning the drone off and on again. b. The battery in the Alpha Drone is low, remove the bat- tery and connect it to the USB charger. c. The left Stick is not in its lowest position. Move the left...
Page 17
Left/Right Roll (Tilt) Forward/Backward Left/Right Pitch (Tilt) Note: Yaw and Pitch can be swapped using the Mode switch. Now Yaw and Pitch are controlled by the opposite thumb stick.
Page 18
Indicators There are LED lights on the underside of the Alpha Drone that indicate when the Alpha Drone is operational (constant) or when the Alpha Drone is running low on battery (flashing). It is important to pay attention to the indicators to avoid an uncontrolled landing, potentially putting your drone and its surrounds at risk.
Page 19
Trimming (fine tuning) Control of the Alpha Drone can be trimmed using the fine- tuning buttons on the Transmitter. If the Alpha Drone is drifting off during a hover or other flight manoeuvre, these buttons are used to counter this drift.
360˚Flip To perform a forward flip press the creatively named Flip button! The drone will launch forward and descend during the flip so make sure that the drone is at an adequate height before performing this manoeuvre. Advanced Flip Mode The Drone also features an advanced flip mode that will enable it to flip in all directions.
Page 21
Left flip 360° Right flip 360° Forward flip 360° Backwards flip 360°...
Micro SD card is present. Once a Micro SD card is inserted, the LED lights will shine a constant blue. If the LED light does not shine a constant blue, turn off the Alpha Drone, remove and re-insert the Micro SD card.
Use a soft brush to remove any particles from the accessible surfaces of the drone. Do not attempt to open the housing of your Alpha Drone, as this will void your warranty and may impede the operation of your Alpha Drone.
Page 24
Replacing Rotor Blades Identify the correct blade needed to replace the current blade. Place your finger gently on the motor cog to steady it. Using the screwdriver provided, remove the lock screw. Take care to place the removed screw in a safe place where it will not be lost.
Micro SD card reader included. 3 Q.) The Alpha Drone/Transmitter LEDs keep flashing. A.) The battery in the Alpha Drone or the Transmitter is running low. In either case it is advisable to switch off both devices and restart with fresh/charged batteries.
Contact Us Having trouble getting your Drone up? Please contact us. No question too big or small and we are more than happy to help. Please visit: www.kaiserbaas.com/support Or email: helpdesk@kaiserbaas.com For further information please visit: www.kaiserbaas.com Tech support: e: helpdesk@kaiserbaas.com w: www.kaiserbaas.com/support p: Australia 1300 302 306 (business hours, AEST)