Motorola Symbol DS6707 Product Reference Manual page 121

The digital imager scanner also interfaces with other USB hosts which support USB Human Interface Devices
(HID). For more information on USB technology, hosts, and peripheral devices, visit www.symbol.com/usb.
To set up the digital imager scanner:
NOTE Interface cables vary depending on configuration. The connectors illustrated in
are examples only. The connectors may be different than those illustrated, but the steps to connect the
scanner are the same.
Connect the modular connector of the USB interface cable to the cable interface port on the digital imager
1.
scanner (see Installing the Interface Cable on page
Plug the series A connector in the USB host or hub, or plug the Plus Power connector in an available port of
2.
the IBM SurePOS terminal.
Select the USB device type by scanning the appropriate bar code from USB Device Type on page 7-5.
3.
On first installation when using Windows, the software prompts to select or install the Human Interface Device
4.
driver. To install this driver, provided by Windows, click Next through all the choices and click Finished on the
last choice. The digital imager scanner powers up during this installation.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
5.
If problems occur with the system, see Troubleshooting on page 3-2.
1-3).
USB Interface 7 - 3
Figure 7-1and Figure 7-2