Copper Cable/Fiber Cable Connection; Power Supply Connection - Edge-Core ES4624-SFP User Manual

2.3.5 Copper Cable/Fiber Cable Connection

Copper cables should be connected as below:
Step 1: Insert one end of the Ethernet cable to the RJ-45 Ethernet port in the switch copper
cable line card;
Step 2: Insert the other end of the Ethernet cable to the RJ-45 Ethernet port of some other
device;
Step 3: Check all status indicators for the corresponding ports; a lighted LED indicates that the
link has been established, otherwise the link is not ready and the cable should be examined.
Caution!
Please verify the sign above the port to ensure using the right port. Connecting to wrong ports
might damage the switch.
Fiber cables should be connected as below:
Step 1: remove the protective plug from the SFP/XFP fiber transceiver bore; Remove the
protective cap from one end of the fiber cable. Keep the fiber end clean and neat.
Step 2: Attach one end of the fiber cable to the SFP/XFP transceiver, and attach the other end to
the transceiver of the corresponding devices. Note: The SFP/XFP transceiver's TX port should be
connected to the RX port of the corresponding device, and vice versa.
Step 3: Check the fiber port status indicator, a lighted LED indicates that the link has been
established; otherwise the link is not ready and should be examined.
Caution!
Please verify the sign above the port to ensure using the other ports. Connecting to wrong ports
might damage the transceiver or the other ports. When connecting other devices through a fiber
cable to the switch, the output power of the fiber cable must not exceed the maximum received
power of the corresponding modules. Otherwise, it will damage the switch. Do not stare at the
fiber bore when the switch is in operation. That may hurt your eyes.

2.3.6 Power Supply Connection

ES4624/26-SFP uses 100-240V AC power supply by default. Please read the power input
specification for the detailed information. -48V DC power supply and AC/DC redundancy power
input are also supported.
AC Power supply connection procedure is described as below:
2-8