Software Upgrade Procedure For Cpc - Panasonic DBS 576 Technical Manual

Section 400: Programming

Software Upgrade Procedure for CPC-576

Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-20-400
1. Power-off the system.
2. Remove the old PC Card from the CPC-576,
and insert the new PC Card.
3. On the CPC card, press and hold down the
MODE button, then power-on the system.
Keep holding the MODE button down until
the "MN" LED starts flashing red.
4. Wait until the RUN (top two) LEDs blink
continuously and the bottom two (MJ and
MN) LEDs remain extinguished.
On installed display phones, "Welcome
•
to DBS" should display on the top line.
5. On the CPC card, press the RESET button.
After a few seconds, the system will shut
•
off, then power-on automatically.
" INITIALIZING" will briefly appear on
•
one of the installed display phones while
the system resets itself.
The CPC LEDs should return to normal
•
(top two LEDs blinking continuously;
bottom two LEDs off).
All installed display phones should show
•
the normal, main menu:
MSG
DBS 576 (USA) issued January 1999
Introduction to
00:07 Wed JAN 01
100 EXT100
PERSONAL DIAL
SYSTEM DIAL
EXTENSION
FUNCTION SYSTEM
FUNCTION EXT
CONF MENU PREV NEXT PROG
DBS 576
Programming
The CPC-576 Card
(front edge, facing out from cabinet)
RUN LED (FPU)
RUN LED (MPU)
MJ LED
MN LED
RESET button
CODE rotary switch
MODE button
RAM HOLD switch
MOH plug-in
•
Page Intro-13
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B