Panasonic DBS 576 Technical Manual page 70

0: System Configuration
Introduction
Option Slot Assignment
(all CPCs) - Version 1.0 or higher
Enter the type of card installed in each of the two Option Slots in the cabinet.
0
System
Configuration
FF1
Cabinet No. 1-6
System
Notes:
FF2
"MFR/8" (DTMF Receiver cards) cannot be automatically detected by the system. You must manually
Trunks
assign them in this address.
Typically, Option Slots are used for SCC (Service Control cards) or TSW (Time Switch cards), which
do not require a code assignment.
FF3
(all except USA) When the RAI unit is mounted on the SCC card, Card Type 61 must be manually
Extensions
assigned for the SCC card in the above address.
Related Programming:
FF4
Card Reset (pg. 8-22)
FF-/Soft Keys
Card Type Verification (pg. 8-22)
Card Version Verification (pg. 8-23)
T1 Loopback 1 Diagnostics (pg. 8-33)
FF5
T1 Loopback 2 Diagnostics (pg. 8-33)
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
•
Page 0-8
02 (1-6) (13 or 14)
13="OP1" option slot
14="OP2" option slot
FF8 0 04 0 BSS Hold (0 or 1) (FLASH + Hold)
FF8 0 04 1 BSS 00 Hold [01-99 displays]
FF8 0 04 1 BSS 01 Hold [Version No. displays]
FF8 0 05 3 BSS(C) Hold (0 or 1) Hold
FF8 0 05 4 BSS(C) Hold 1 Hold
DBS 576 (USA) issued January 1999
Hold (50 or 61)
Card Type No. 50 (for MFR/8)
or 61 (for SCC w/RAI-all except USA)
Section 400: Programming
113 :50
Card ID # for OP
Hold
576-20-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B