Disassembly Instructions - Mitsubishi Electric MXZ-3C24NA Service Manual

12

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
12-1. MXZ-3C24NA MXZ-3C30NA MXZ-4C36NA
OPERATING PROCEDURE
1. Removing the panels
(1) Remove the screws fixing the top panel, and remove the
top panel.
(2) Remove the screws fixing the service panel.
(3) Pull down the service panel, and remove the service
panel.
(4) Disconnect the power supply and indoor/outdoor connect-
ing wire.
(5) Remove the screws fixing the front panel, and remove the
front panel.
(6) Remove the screws fixing the back panel, and remove
the back panel.
Photo 3
Catch of the front panel
Screws of the front panel
Screws of the front panel
OBH702A
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Catch of the front panel
Screws of the back panel
77
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
NOTE: Turn OFF the power supply before disassembly.
PHOTOS
Photo 1
Screws of the top panel
Screws of the service panel
Photo 2
Screws of the top panel
Photos : MXZ-4C36NA