OPERATING PROCEDURE
5. Removing the expansion valve
(1) Remove the top panel, and the service panel (Refer to 1).
(2) Disconnect the power supply and indoor/outdoor connect-
ing wire.
(Gas recovery is not required if the unit is pumped down.)
(3) Remove the LEV coils.
(4) Detach the brazed parts of expansion valves and pipes.
© Copyright 2014 MITSUBISHI ELECTRIC CORPORATION
Distributed in Oct. 2014. No. OBH702 REVISED EDITION-A
Distributed in Sep. 2014. No. OBH702
Made in Japan
OBH702A
HEAD OFFICE: TOKYO BLDG., 2-7-3, MARUNOUCHI, CHIYODA-KU, TOKYO 100-8310, JAPAN
Photo 11
Discharge pipe
brazed part
Compressor nuts
New publication, effective Oct. 2014
Specifications are subject to change without notice.
84
PHOTOS
Suction pipe
brazed part
Expansion
LEV coils
valves