Transmitter/Receiver - Polaris Automatic Gate Operators 500 Single User Manual

beeps verify LEARN CODE has been cleared.
Figure 25

TRANSMITTER/RECEIVER

NOTE: All Polaris Automatic Gate Operator
transmitters use a standard code set at the
factory. It is recommended that this code is re-set DIP Switches
for safety and security before programming
receiver.
Step 1
Remove the battery access cover on the
transmitter. When the cover is off, you will see
the battery and the DIP switches.
Step 2
The DIP switch block contains 10 small switches.
Using a small screwdriver or pen, move any
switch or combination of the switches to either the
open or closed position.
NOTE: Do not set the switches to all open or all
Transmitter
closed.
Step 3
Locate the LEARN CODE button on the circuit
board in the control box.
Step 4
Figure 26
Press and hold the LEARN CODE button for at
least three seconds, but no more than five
seconds. Upon release, the CHARGING LED will
light, the STATUS LED will stop blinking, and an
audible beep will occur verifying the circuit board
is in the learn code mode.
Step 5
Press and hold the transmitter button until the
CHARGING LED turns off, the STATUS light
blinks, and an audible beep occurs. Release the
transmitter button. The transmitter code is now set.
Step 6
Replace the battery access cover on the transmitter.
Step 7
Verify the transmitter is operational by pressing
the transmitter button. The LED
RADIO RECEIVER
will light and the gate will move if the setting is
correct.
If the gate does not move, repeat the process
starting with step 4.
NOTE: The control box circuit board can learn
and hold up to 10 different codes.
NOTE: To clear all codes, press and hold the
LEARN CODE button for 10 seconds. Two audible