Installation; Declaration Of Conformity; Before Installation - Latronics PVE1200 Instruction Manual

INSTALLATION

Grid Interactive Solar Systems have become increasingly popular in recent
!
years. These systems do not necessarily require batteries for storage and
therefore can have a very simple configuration.
Photovoltaic Cells
PV Edge

BEFORE INSTALLATION

Ensure the Inverter has not been damaged in transit.
!
The unit must be placed in a well ventilated and protected area, not exposed
!
to the open environment, and free from contaminates (i.e. exhaust gases,
sea air, dust etc.).
The PV Edge is designed for indoor installation in a suitable location where
!
ambient temperature will not exceed rated values.
If the PV Edge is to be installed outdoors, please use the Latronics Outdoor
!
Enclosure (Part no: OE)
The Inverter can be mounted horizontal on table or floor. The Inverter can
!
also be mounted on a wall, taking note of the sticker being the correct
orientation.
It is important that all wiring in the installation complies with the relevant
standards such as AS4777 and AS3000 .
Any work carried out is to be preformed by
Qualified and Licensed personnel.
Mains
2

DECLARATION OF CONFORMITY

Manufacturer:
Latronic Sunpower Pty Ltd
105 Grigor St West
Moffat Beach Industrial Park
Caloundra Queensland 4551
Australia
Declare that the PV Edge grid connected Inverter Model No. PVE1200 and
PVE2500 conform to the requirements of following standards
EN61000-6-1
EN61000-6-3
EN55014
AS1044
EN60335-1
AS3100
AS4777
And therefore conform to the regulations of the EC directives
Directive 2004/108/CE (EMC directive), Directive 2006/95/CE (low Voltage
Directive)
Date that CE marking was first affixed 2007
Also conforms to the regulations of C-tick mark for Australian emission standards
Australian Safety Certificate approval number CS06713V
All products are manufactured with full traceability in accordance with the
Quality System Requirements of AS/NZS ISO 9002
Signed
William Pettit
Electronic Engineer
th
7 Feb 2009
19