Diamond DA20-C1 Maintenance Manual page 64

Maintenance Practices
5. Prepare the area(s) of the cowling for the
application of the high temperature paint, as
follows:
- If dirt or grease is present, wash the area
with clean carbon tetrachloride or
acetone. Wipe the area off immediately
- Abrade the surface with 280 grit
sandpaper
- Remove the dust with a fully opened tack
cloth
- Cover the area(s) of the cowling that will
not be painted. Use masking tape to hold
the cover(s) in place.
WARNING:
WARNING:
Page 202
30 Oct 09
Detail Steps/Work Items
OBEY THE SAFETY PRECAUTIONS THAT FOLLOW WHEN YOU
USE PAINTS:
- USE SAFETY GOGGLES
- USE SAFETY CLOTHING
- DO NOT LET PAINTS TOUCH YOUR SKIN, EYES, OR
MOUTH
- PAINTS ARE POISONOUS
- IF IRRITATION OCCURS, GET MEDICAL AID
- DO THE WORK IN AN AREA THAT HAS A GOOD FLOW OF
AIR
- DO THE WORK IN AN AREA THAT DOES NOT HAVE
SPARKS, FLAME, OR HOT SURFACES.
- OBEY THE MANUFACTURER'S INSTRUCTIONS.
- THE TEMPERATURE MUST BE BETWEEN 65 AND 120
o
(18 AND 49
- THE RELATIVE HUMIDITY MUST BE BETWEEN 25 AND 80
PERCENT.
YOU CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO
EQUIPMENT IF ABOVE SAFETY PRECAUTIONS ARE NOT OBEYED
53-10-00
For approved materials and suppliers, refer
to Chapter 51-00.
Make sure that you do not damage the
laminate. Only remove the transparent top
coat and the fire resistant paint.
C).
Key Items/References
o
F
DA20-C1 AMM
DA201-C1
Rev 16